Corrigendum to Commission Implementing Decision (EU) 2024/2974 of 29 November 2024 establishing the best available techniques (BAT) conclusions, under Directive 2010/75/EU of the European Parliament and of the Council on industrial emissions, for the smitheries and foundries industry

( Official journal of the European Union L, 2024/2974, 6 December 2024 )

On page 44, in Table 1.8, footnotes:

for:

(a)	organic binder systems generating low or no emissions of substances classified as CMR 1A, CMR 1B or CMR 2 (see techniques (d), (e) and/or (f) in BAT 25) are used in core-making;

(b)

one or both of the following conditions are met:

—	thermal or catalytic oxidation is not applicable,

—

substitution with water-based coatings is not applicable.

(1)	The BAT-AEL only applies in the cold-box process when amines are used.

(2)	The BAT-AEL only applies when aromatic binders/chemicals are used.

(3)	The BAT-AEL only applies when the substance concerned is identified as relevant in the waste gas streams based on the inventory of inputs and outputs mentioned in BAT 2.

(4)	The BAT-AEL only applies when phenolic-based binder systems are used.

(5)	In the case of core-making, the upper end of the BAT-AEL range may be higher and up to 100 mg C/Nm3 if both of the following conditions (a) and (b) are met:

read:

(1)	The BAT-AEL only applies in the cold-box process when amines are used.

(2)	The BAT-AEL only applies when aromatic binders/chemicals are used.

(3)	The BAT-AEL only applies when the substance concerned is identified as relevant in the waste gas streams based on the inventory of inputs and outputs mentioned in BAT 2.

(4)	The BAT-AEL only applies when phenolic-based binder systems are used.

(5)

In the case of core-making, the upper end of the BAT-AEL range may be higher and up to 100 mg C/Nm3 if both of the following conditions (a) and (b) are met:

(a)	organic binder systems generating low or no emissions of substances classified as CMR 1A, CMR 1B or CMR 2 (see techniques (d), (e) and/or (f) in BAT 25) are used in core-making;

(b)

one or both of the following conditions are met:

—	thermal or catalytic oxidation is not applicable,

—	substitution with water-based coatings is not applicable.