EUR-Lex Access to European Union law

Back to EUR-Lex homepage

This document is an excerpt from the EUR-Lex website

Stands for two-wheel vehicles

Legal status of the document This summary has been archived and will not be updated. See 'Požiadavky na typové schvaľovanie a dohľad nad trhom pre dvoj- alebo trojkolesové vozidlá a štvorkolky v EÚ' for an updated information about the subject.

Stands for two-wheel vehicles

This Directive forms part of the harmonisation of national laws on EC type-approval for two or three-wheel vehicles. It lays down the rules applying to the design and production of stands used on this of vehicle.

ACT

Directive 2009/78/EC of the European Parliament and of the Council of 13 July 2009 on stands for two-wheel motor vehicles (Text with EEA relevance).

SUMMARY

This Directive introduces the technical provisions necessary for the production and approval of stands for two-wheel motor vehicles. It falls within the scope of Directive 2002/24/EC relating to the type-approval of two or three-wheel motor vehicles.

This Directive applies to the following types of vehicle:

  • mopeds: two- or three-wheeled vehicles fitted with an engine having a cylinder capacity not exceeding 50 cm3 and a maximum design speed of not more than 45 km/h;
  • motorcycles: two-wheeled vehicles with or without a side-car, fitted with an engine having a cylinder capacity of more than 50 cm3 and/or a maximum design speed of more than 45 km/h.

A stand is a device that is firmly attached to the vehicle and is able to maintain the vehicle in its vertical (or almost vertical) parking position when left unattended by its driver.

All two-wheeled vehicles must be fitted with at least one stand (prop, centre or both) to ensure that they are stable when stationary. Annex I to this Directive lays down the requirements for prop and centre stands.

Vehicles may also be fitted with a tell-tale indicating the position of the stand (retracted or travelling position).

Approval is granted according to the following procedure:

  • the application for approval is submitted by the manufacturer or producer to the competent authority of a Member State;
  • the competent authority grants approval for the stand if it complies with the requirements of this Directive and corresponds to the information provided by the producer;
  • the competent authority then completes the approval certificate in Annex to the Directive.

This Directive repeals Directive 93/31/EEC. It applies with effect from 1 January 2010.

Reference

Act

Entry into force

Deadline for transposition in the Member States

Official Journal

Directive 2009/78/EC

23.9.2009

-

OJ L231 of 3.9.2009

Last updated: 13.01.2010

Top