11.4.2014   

EN

Official Journal of the European Union

C 110/1

Note 1:

Generally the date of cessation of presumption of conformity will be the date of withdrawal (‘dow’), set by the European standardisation organisation, but attention of users of these standards is drawn to the fact that in certain exceptional cases this can be otherwise.

Note 2.1:

The new (or amended) standard has the same scope as the superseded standard. On the date stated, the superseded standard ceases to give presumption of conformity with the essential or other requirements of the relevant Union legislation.

Note 2.2:

The new standard has a broader scope than the superseded standard. On the date stated the superseded standard ceases to give presumption of conformity with the essential or other requirements of the relevant Union legislation.

Note 2.3:

The new standard has a narrower scope than the superseded standard. On the date stated the (partially) superseded standard ceases to give presumption of conformity with the essential or other requirements of the relevant Union legislation for those products or services that fall within the scope of the new standard. Presumption of conformity with the essential or other requirements of the relevant Union legislation for products or services that still fall within the scope of the (partially) superseded standard, but that do not fall within the scope of the new standard, is unaffected.

Note 3:

In case of amendments, the referenced standard is EN CCCCC:YYYY, its previous amendments, if any, and the new, quoted amendment. The superseded standard therefore consists of EN CCCCC:YYYY and its previous amendments, if any, but without the new quoted amendment. On the date stated, the superseded standard ceases to give presumption of conformity with the essential or other requirements of the relevant Union legislation.

—

Any information concerning the availability of the standards can be obtained either from the European standardisation organisations or from the national standardisation bodies the list of which is published in the Official Journal of the European Union according to Article 27 of the Regulation (EU) No1025/2012. (2)

—

Standards are adopted by the European standardisation organisations in English (CEN and Cenelec also publish in French and German). Subsequently, the titles of the standards are translated into all other required official languages of the European Union by the national standardisation bodies. The European Commission is not responsible for the correctness of the titles which have been presented for publication in the Official Journal.

—

References to Corrigenda ‘.../AC:YYYY’ are published for information only. A Corrigendum removes printing, linguistic or similar errors from the text of a standard and may relate to one or more language versions (English, French and/or German) of a standard as adopted by a European standardisation organisation.

—

Publication of the references in the Official Journal of the European Union does not imply that the standards are available in all the official languages of the European Union.

—

This list replaces all the previous lists published in the Official Journal of the European Union. The European Commission ensures the updating of this list.

—

More information about harmonised standards and other European standards on the Internet at

http://ec.europa.eu/enterprise/policies/european-standards/harmonised-standards/index_en.htm

—

CEN: Avenue Marnix 17, B-1000, Brussels, Tel.+32 2 5500811; fax + 32 2 5500819 (http://www.cen.eu)

—

CENELEC: Avenue Marnix 17, B-1000, Brussels, Tel.+32 2 5196871; fax + 32 2 5196919 (http://www.cenelec.eu)

—

ETSI: 650, route des Lucioles, F-06921 Sophia Antipolis, Tel.+33 492 944200; fax +33 493 654716, (http://www.etsi.eu)